Waypointing: need help please, This is SOOoo.. much harder than WB Options

[Depot]

I have waypointed scores of custom maps for Whichbot so I'm hardly a noob at this (can do an average map in under 15 minutes). But let me tell you, this system here is a LOAD of work.

The main issue I have atm is multiple paths being created from 1 waypoint. I began my work in the base on a mvm map and started laying waypoints, and before I got to the door there were multiple paths from 1 waypoint in several different areas.

What is the menu sequence for dropping waypoints, and the paths going from point a, to point b, to point c, and so on?

[Gruuunt]

For a kwik method just copy and rename your old whichbot waypoints (or any new ones you create:)

Change 'em from: .wpt to .rcw, and you will find all the paths are then single pathways like you are used to. Ladder waypoints normally stay the same, but you need to re-position them at the top as RcBot doesnt like them to far out. Door waypoints will have to be deleted and re-done again as that flag isn't picked up.

Use Sandy and Skitchys tips as well and you will find an easier life waypointing RcBot.

BTW Depot how about scooting over to http://www.waypoint-world.com and upping some of your waypoints!
Same applies to any other waypointers for RcBot WhichBot etc, Sandy and me are already contributing there